The wiring steps of the waterproof power supply are as follows:
Prepare tools and materials:
Wires
Waterproof connector assembly
Wire crimping pliers
Wire stripping pliers
Wiring steps:
Put the wires through the rubber pellets and strip them with wire strippers.
Use wire crimping pliers to crimp the female connector.
Put the female connector into the female housing and make sure you hear a "click" sound to indicate that it is in place.
Install the red fixing assembly to ensure that the female connector is fully connected.
Perform the same operation on the male connector, i.e. stripping, crimping, installing the housing and fixing assembly.
Connect the male connector to the female connector, and pay attention to the corresponding wires, such as white wire to white wire, black wire to black wire.
